Message list
All the pages were recognized as blank.
An error in the ScanSnap's hardware. (0xXXXXXXXX)
Turn the ScanSnap off then back on, and try again.
An error occurred while transferring data from the ScanSnap. (0xXXXXXXXX)
Turn the ScanSnap off then back on, and try again.
An error occurred with the ScanSnap. (0xXXXXXXXX)
Turn the ScanSnap off then back on, and try again.
Communication error. Wait for a while, and then try again.
If the error persists, change the port.
Connection failed.
Check if "Scan to Mobile" on the computer is running properly, and the computer can be connected to your mobile device.
Connection failed.
Exit the ScanSnap Wireless Setup Tool.
Connection failed.
To connect to the ScanSnap directly, make sure that the ScanSnap is turned on and not being used by another device.
Connection with ScanSnap was cut off because there was no scan for 15 minutes.
Do you want to connect again?
Do you want to delete this file?
Error in optical system.
Turn the ScanSnap off then back on, and try again.
Failed to communicate with ScanSnap.
Check the status of the ScanSnap, and then try again.
Failed to communicate with the ScanSnap.
Try again.
Failed to communicate with the ScanSnap.
Turn the ScanSnap off then back on, and try again.
Failed to receive the file.
Check if "Scan to Mobile" on the computer is running properly.
Load the next document.
More than one destination was detected.
Specify the destination from [Settings] on the [File List] screen.
No available destination was detected.
Confirm the status of the destination.
Overlapping document detected.
If you are discarding the image, return the overlapped documents to the feeder.
Paper jam occurred.
Open the ADF top section and remove the document.
PDF file reached the maximum size (1,000 pages).
Receiving files has been canceled.
Scanning was stopped because a Carrier Sheet has been detected.
Carrier Sheet is not supported.
ScanSnap is disconnected.
Exit the ScanSnap Wireless Setup Tool, and then select ScanSnap from [Connect to:].
ScanSnap is disconnected.
To perform scanning again, select ScanSnap from [Connect to:].
The ADF top section is open.
Close the ADF top section.
The destination could not be found.
Check if it is connected to the same network.
The file may not be displayed properly in the specified application due to insufficient memory. Do you want to transfer the file anyway?
The ScanSnap is turned off.
Turn the ScanSnap back on, and try again.
There is no paper in the ADF paper chute (cover).
Load the document in the ADF paper chute (cover) correctly.
Unable to open the file because the file format cannot be recognized or is invalid.
Unable to proceed due to insufficient memory. If this problem persists after exiting unnecessary applications, scan the document at a lower image quality, and then send the file again from your computer.
Unable to receive the file due to insufficient disk space.
Delete unnecessary files, and try again.
When non-alphanumeric characters are included in a file name, it may not be displayed correctly in some e-mail applications.
Do you want to rename the file that you are sending?