 |
|
FAQ - fi-5110EOX2 |
|
 |
How can I reduce miss feed (double feed) problems? |
|
|
|
 |
Miss feeding (multiple feeding) problems are usually caused by dirty or worn pads (if the miss fed documents meet specifications).
- Clean the automatic feeding area, especially around the Pad ASSY and the Pick roller, following the procedures outlined in the Operator's Guide.
Be careful not to bend the metal part (pick spring) of the Pad (as this may also cause multiple feeding problems).
- Fan the document
- Remove a stack of paper that is no thicker than 5mm.
- Hold both ends of the document and bend it as shown in the diagram.
- Firmly holding the document with both hands and bend back the document as follows so that the bent section rises up in the middle of the document.
- Repeat step(1) to (3) a few times.
- Turn the document staple 90 degrees, hold the other two sides of the document, and fan it again.
- Load the document onto the paper chute cover.
Make sure that document edges closest to the scanner are not lined up vertically.
The document to be scanned should look like a flight of stairs, as shown below.
- Adjust the side guides to the document width.
- Be sure to replace consumables.
Consumables and replacement cycles:
- fi-5110EOX Pad ASSY (PA03360-0002): 50,000 sheets or one year.
- fi-5110EOX Pick roller (PA03360-0001): 100,000 sheets or one year.
|
|
|
 |
 |
|
|
|
